EasyManuals Logo

NETGEAR 7300 Series User Manual

NETGEAR 7300 Series
364 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #211 background imageLoading...
Page #211 background image
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-29
202-10009-01_060204
ip rip
This command enables RIP on a router interface.
Default Disabled
Format
ip rip
Mode Interface Config
no ip rip
This command disables RIP on a router interface.
Format
no ip rip
Mode Interface Config
ip rip authentication
This command sets the RIP Version 2 Authentication Type and Key for the specified interface. The
value of <type> is either none, simple, or encrypt.
The value for authentication key [key] must be 16 bytes or less. The [key] is composed of standard
displayable, non-control keystrokes from a Standard 101/102-key keyboard. If the value of <type>
is encrypt, a keyid in the range of 0 and 255 must be specified.
Default The default authentication type is none.
Default The default password key is an empty string. Unauthenticated
interfaces do not need an authentication key.
Default The default key id is not defined. Unauthenticated interfaces do
not need an authentication key id.
Format
ip rip authentication {none | {simple <key>} |
{encrypt <key> <keyid>}}
Mode Interface Config
no ip rip authentication
This command sets the default RIP Version 2 Authentication Type.
Format
no ip rip authentication
Mode Interface Config

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR 7300 Series and is the answer not in the manual?

NETGEAR 7300 Series Specifications

General IconGeneral
ModelNETGEAR 7300 Series
Form FactorRack-mountable
VLAN SupportYes
Jumbo Frame Support9KB
ManagementWeb-based, CLI
LayerLayer 2/3

Related product manuals