User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-93
202-10009-01_060204
users passwd
This command changes the password of an existing operator. User password should not be more
than eight characters in length. If a user is authorized for authentication or encryption is enabled,
password must be eight alphanumeric characters in length. The username and password are not
case-sensitive. When a password is changed, a prompt will ask for the operator’s former password.
If none, press enter.
Default No Password
Format
users passwd <username>
Mode Global Config
no users passwd
This command sets the password of an existing operator to blank. When a password is changed, a
prompt will ask for the operator's former password. If none, press enter.
Format
no users passwd <username>
Mode Global Config
users snmpv3 accessmode
This command specifies the snmpv3 access privileges for the specified login user. The valid
accessmode values are
readonly or readwrite. The <username> is the login user name for which
the specified access mode will apply.
Default
readwrite for admin user; readonly for all other users
Format
users snmpv3 accessmode <username> {readonly | read-
write}
Mode Global Config
no users snmpv3 accessmode
This command sets the snmpv3 access privileges for the specified login user as readwrite for
admin user; readonly for all other users. The <username> is the login user name for which the
specified access mode will apply.
Format
no users snmpv3 accessmode <username>
Mode Global Config
To Next Page
Loading...
Need help?
General
