NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Quick Start up 6-7
202-10009-01_060204
Quick Start up Factory Defaults
Table 6-8. Quick Start up Factory Defaults
Command Details
clear config Enter yes when the prompt pops up to clear all the configurations
made to the switch.
copy system:running-config
nvram:startup-config
Enter yes when the prompt pops up that asks if you want to save
the configurations made to the switch.
reload OR Cold Boot the Switch Enter yes when the prompt pops up that asks if you want to reset
the system.
This is the users choice either reset the switch or cold boot the
switch, both work effectively.

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3