User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-19
202-10009-01_060204
Restrictions Routed frames are always Ethernet encapsulated when a frame is
routed to a VLAN.
exit-overflow-interval
This command configures the exit overflow interval for OSPF. It describes the number of seconds
after entering Overflow state that a router will wait before attempting to leave the Overflow State.
This allows the router to again originate non-default AS-external-LSAs. When set to 0, the router
will not leave Overflow State until restarted. The range for <seconds> is 0 to 2147483647 seconds.
Default 0
Format
exit-overflow-interval <0-2147483647>
Mode Router OSPF Config
no exit-overflow-interval
This command configures the default exit overflow interval for OSPF.
Format
no exit-overflow-interval
Mode Router OSPF Config
external-lsdb-limit
This command configures the external LSDB limit for OSPF. If the value is -1, then there is no
limit. When the number of non-default AS-external-LSAs in a router's link-state database reaches
the external LSDB limit, the router enters overflow state. The router never holds more than the
external LSDB limit non-default AS-external-LSAs in it database. The external LSDB limit
MUST be set identically in all routers attached to the OSPF backbone and/or any regular OSPF
area. The range for <limit> is -1 to 2147483647.
Default -1
Format
external-lsdb-limit <-1-2147483647>
Mode Router OSPF Config
no external-lsdb-limit
This command configures the default external LSDB limit for OSPF.
Format
no external-lsdb-limit
Mode Router OSPF Config
To Next Page
Loading...
Need help?
General
