User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
CLI Commands: Differentiated Services 10-7
202-10009-01_060204
Default None
Format match [not] destination-address mac <macaddr> <mac-
mask>
Mode Class-Map Config
match dstip
This command adds to the specified class definition a match condition based on the destination IP
address of a packet. The <ipaddr>
parameter specifies an IP address. The <ipmask> parameter
specifies an IP address bit mask; note that although similar to a standard subnet mask, this bit mask
need not be contiguous. The optional [
not] parameter has the effect of negating this match
condition for the class (i.e., match all destination IP addresses except for what is specified here).
Default
None
Format match [not] dstip <ipaddr> <ipmask>
Mode Class-Map Config
match dstl4port
This command adds to the specified class definition a match condition based on the destination
layer 4 port of a packet using a single keyword or numeric notation or a numeric range notation.
To specify the match condition as a single keyword, the value for <
portkey> is one of the supported
port name keywords. The currently supported <
portkey> values are: domain, echo, ftp, ftpdata, http,
smtp, snmp, telnet, tftp, www
. Each of these translates into its equivalent port number, which is used as
both the start and end of a port range.
To specify the match condition using a numeric notation, one layer 4 port number is required. The
port number is an integer from 0 to 65535.
To specify the match condition using a numeric range notation, two layer 4 port numbers are
required and together they specify a contiguous port range. Each port number is an integer from 0
to 65535, but with the added requirement that the second number be equal to or greater than the
first.
The optional [not] parameter has the effect of negating this match condition for the class (i.e.,
match all destination layer 4 port numbers except for the one specified here).
Default
None
To Next Page
Loading...
Need help?
General
