NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-101
202-10009-01_060204
no dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state machine on
this port to the default values. Depending on the token used, the corresponding default values are
set.
Format no dot1x timeout {reauth-period | quiet-period | tx-period | supp-
timeout | server-timeout}
Mode
Interface Config
dot1x user
This command adds the specified user to the list of users with access to the specified port or all
ports. The <user> parameter must be a configured user.
Format dot1x user <user> {<slot/port> | all}
Mode Global Config
no dot1x user
This command removes the user from the list of users with access to the specified port or all ports.
Format no dot1x user <user> {<slot/port> | all}
Mode
Global Config
radius accounting mode
This command is used to enable the RADIUS accounting function.
Default
Disabled
Format radius accounting mode
Mode Global Config
no radius accounting mode
This command is used to set the RADIUS accounting function to the default value - i.e. the
RADIUS accounting function is disabled.
Format no radius accounting mode
Mode
Global Config

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3