User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
CLI Commands: Differentiated Services 10-15
202-10009-01_060204
police-simple
This command is used to establish the traffic policing style for the specified class. The simple form
of the police command uses a single data rate and burst size, resulting in two outcomes: conform
and nonconform. The conforming data rate is specified in kilobits-per-second (Kbps) and is an
integer from 1 to 4294967295. The conforming burst size is specified in kilobytes (KB) and is an
integer from 1 to 128.
For each outcome, the only possible actions are drop, set-dscp-transmit, set-prec-transmit, or
transmit. In this simple form of the police command, the conform action defaults to transmit and
the violate action defaults to drop. These actions can be set with this command once the style has
been configured.
For set-dscp-transmit, a <
dscpval> value is required and is specified as either an integer from 0 to
63, or symbolically through one of the following keywords:
af11, af12, af13, af21, af22, af23, af31, af32,
af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef
.
For set-prec-transmit, an IP Precedence value is required and is specified as an integer from 0-7.
Format
police-simple {<1-4294967295> <1-128> conform-action
{drop | set-prec-transmit <0-7> | set-dscp-transmit
<0-63> | transmit} [violate-action {drop | set-prec-
transmit <0-7> | set-dscp-transmit <0-63> | trans-
mit}]}
Mode Policy-Class-Map Config
Restrictions Only one style of police command (simple, singlerate, tworate) is
allowed for a given class instance in a particular policy.
Policy Type In
Incompatibilities Mark IP DSCP, Mark IP Precedence
Service Commands
The 'service' command set is used in DiffServ to define:
Traffic Conditioning Assign a DiffServ traffic conditioning policy (as specified by the
policy commands) to an interface in the incoming direction
Service Provisioning Assign a DiffServ service provisioning policy (as specified by the
policy commands) to an interface in the outgoing direction
To Next Page
Loading...
Need help?
General
