User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-77
202-10009-01_060204
no vlan pvid
This command sets the VLAN ID per interface to 1.
Format
no vlan pvid <1-4094>
Mode Interface Config
vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to enabled. If
tagging is enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is
transmitted as untagged frames. The ID is a valid VLAN identification number.
Format
vlan tagging <1-4094>
Mode Interface Config
no vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to disabled. If
tagging is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN
identification number.
Format
no vlan tagging <1-4094>
Mode Interface Config
Spanning Tree Commands
This section provides detailed explanation of the spanning tree commands. The commands are
divided into two functional groups:
• Show commands display spanning tree settings, statistics, and other information.
• Configuration Commands configure features and options of the switch. For every
configuration command there is a show command that displays the configuration setting.
show spanning-tree
This command displays spanning tree settings for the common and internal spanning tree, when
the optional parameter “brief” is not included in the command. The following details are
displayed.
To Next Page
Loading...
Need help?
General
