User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-42 Switching Commands
202-10009-01_060204
no port lacpmode all
This command disables Link Aggregation Control Protocol (LACP) on all ports.
Format
no port lacpmode all
Mode Global Config
port-channel
This command configures a new port-channel (LAG) and generates a logical slot and port number
for it. Display this number using the “show port-channel”.
Note: Before including a port in a port-channel, set the port physical mode. See ‘speed’ command.
Format
port-channel <name>
Mode Global Config
port-channel adminmode
This command enables a port-channel (LAG). The interface is a logical slot and port for a
configured port-channel. The option
all sets every configured port-channel with the same
administrative mode setting.
Format
port-channel adminmode {<logical slot/port> | all}
Mode Global Config
no port-channel adminmode
This command disables a port-channel (LAG). The interface is a logical slot and port for a
configured port-channel. The option
all sets every configured port-channel with the same
administrative mode setting.
Format
no port-channel adminmode {<logical slot/port> | all}
Mode Global Config
port-channel linktrap
This command enables link trap notifications for the port-channel (LAG). The interface is a logical
slot and port for a configured port-channel. The option
all sets every configured port-channel
with the same administrative mode setting.
To Next Page
Loading...
Need help?
General
