NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-56 Routing Commands
202-10009-01_060204
split-horizon
This command sets the RIP split horizon mode.
Default simple
Format
split-horizon {none | simple | poison}
Mode Router RIP Config
no split-horizon
This command sets the default RIP split horizon mode.
Format
no split-horizon
Mode Router RIP Config
trapflags
This command enables OSPF traps.
Default Enabled
Format
trapflags
Mode Router OSPF Config
no trapflags
This command disables OSPF traps.
Format
no trapflags
Mode Router OSPF Config
vlan routing
This command creates routing on a VLAN. The <vlanid> value has a range from 1 to 4094.
Format
vlan routing <vlanid>
Mode VLAN Database
no vlan routing
This command deletes routing on a VLAN. The <vlanid> value has a range from 1 to 4094.

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3