User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-14 Switching Commands
202-10009-01_060204
GMRP Learned The value of the corresponding was learned via
GMRP and applies to Multicast.
Other The value of the corresponding instance does not fall into
one of the other categories.
show msglog
This command displays the message log maintained by the switch. The message log contains
system trace information.
The trap log contains a maximum of 256 entries that wrap.
Format
show msglog
Mode Privileged EXEC
Message The message that has been logged.
Note: Message log information is not retained across a switch reset.
show running-config
This command is used to display the current setting of different protocol packages supported on
switch. This command displays only those parameters, the values of which differ from default
value. The output is displayed in the script format, which can be used to configure another switch
with same configuration.
Format
show running-config
Mode Privileged EXEC
show sysinfo
This command displays switch information.
Format
show sysinfo
Mode
Privileged EXEC
Switch Description Text used to identify this switch.
System Name Name used to identify the switch.
System Location Text used to identify the location of the switch. May be up to 31
alpha-numeric characters. The factory default is blank.
To Next Page
Loading...
Need help?
General
