NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-32 Routing Commands
202-10009-01_060204
Mode Global Config
no ip route distance
This command sets the default static route preference value in the router. Lower route preference
values are preferred when determining the best route.
Format
no ip route distance
Mode Global Config
ip routing
This command enables the IP Router Admin Mode for the master switch.
Format
ip routing
Mode Global Config
no ip routing
This command disables the IP Router Admin Mode for the master switch.
Format
no ip routing
Mode Global Config
redistribute
This command configures OSPF protocol to redistribute routes from the specified source protocol/
routers.
Default value for metric unspecified
Default value for type 2
Default value for tag 0
Format
redistribute {rip | bgp | static | connected} [metric
<0-16777215>] [metric-type {1 | 2}] [tag <0-
4294967295>] [subnets]
Mode Router OSPF Config

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3