User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-48 Routing Commands
202-10009-01_060204
Hello Interval Is the configured hello interval for the OSPF virtual interface.
Dead Interval Is the configured dead interval for the OSPF virtual interface.
Iftransit Delay Interval Is the configured transit delay for the OSPF virtual interface.
Retransmit Interval Is the configured retransmit interval for the OSPF virtual inter-
face.
Authentication Type Is the configured authentication type of the OSPF virtual inter-
face.
State The OSPF Interface States are: down, loopback, waiting, point-
to-point, designated router, and backup designated router. This is
the state of the OSPF interface.
Neighbor State Displays the neighbor state.
show ip ospf virtual-link brief
This command displays the OSPF Virtual Interface information for all areas in the system.
Format
show ip ospf virtual-link brief
Mode Privileged EXEC and User EXEC
Area Id Is the area id of the requested OSPF area.
Neighbor Is the neighbor interface of the OSPF virtual interface.
Hello Interval Is the configured hello interval for the OSPF virtual interface.
Dead Interval Is the configured dead interval for the OSPF virtual interface.
Retransmit Interval Is the configured retransmit interval for the OSPF virtual inter-
face.
Transit Delay Is the configured transit delay for the OSPF virtual interface.
show ip rip
This command displays information relevant to the RIP router.
Format
show ip rip
Mode Privileged EXEC and User EXEC
Router ID Is a 32 bit dotted decimal number representing the interface.
To Next Page
Loading...
Need help?
General
