EasyManuals Logo

NETGEAR 7300 Series User Manual

NETGEAR 7300 Series
364 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #132 background imageLoading...
Page #132 background image
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-66 Switching Commands
202-10009-01_060204
Mode Interface Config
no shutdown
This command enables a port.
Format
no shutdown
Mode Interface Config
shutdown all
This command disables all ports.
Default
Enabled
Format shutdown all
Mode Global Config
no shutdown all
This command enables all ports.
Format
no shutdown all
Mode Global Config
snmp trap link-status
This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See ‘snmp-server
enable traps linkmode’ command.
Format
snmp trap link-status
Mode Interface Config
no snmp trap link-status
This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See ‘snmp-server
enable traps linkmode’ command).
Format
no snmp trap link-status

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR 7300 Series and is the answer not in the manual?

NETGEAR 7300 Series Specifications

General IconGeneral
ModelNETGEAR 7300 Series
Form FactorRack-mountable
VLAN SupportYes
Jumbo Frame Support9KB
ManagementWeb-based, CLI
LayerLayer 2/3

Related product manuals