User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
CLI Commands: Differentiated Services 10-5
202-10009-01_060204
This command may be issued at any time; if the class is currently referenced by one or more
policies or by any other class, this deletion attempt shall fail.
Format
no class-map <classname>
Mode Global Config
class-map rename
This command changes the name of a DiffServ class. The <classname> is the name of an existing
DiffServ class. The
<newclassname> parameter is a case-sensitive alphanumeric string from 1 to
31 characters uniquely identifying the class.
Note: The class name ‘default’ is reserved and must not be used here.
Default None
Format
class-map rename <classname> <newclassname>
Mode Global Config
match any
This command adds to the specified class definition a match condition whereby all packets are
considered to belong to the class. The optional [
not] parameter has the effect of negating this match
condition for the class (i.e., none of the packets are considered to belong to the class).
Default
None
Format match [not] any
Mode Class-Map Config
match class-map
This command adds to the specified class definition the set of match conditions defined for another
class. The <
refclassname> is the name of an existing DiffServ class whose match conditions are
being referenced by the specified class definition.
Note: There is no [not] option for this match command.
Default
None
Format match class-map <refclassname>
Mode Class-Map Config
To Next Page
Loading...
Need help?
General
