User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-30 Switching Commands
202-10009-01_060204
no snmp-server community ipaddr
This command sets a client IP address for an SNMP community to 0.0.0.0. The name is the
applicable community name.
Format
no snmp-server community ipaddr <name>
Mode Global Config
snmp-server community ipmask
This command sets a client IP mask for an SNMP community. The address is the associated
community SNMP packet sending address and is used along with the client IP address value to
denote a range of IP addresses from which SNMP clients may use that community to access the
device. A value of 255.255.255.255 will allow access from only one station, and will use that
machine's IP address for the client IP Address. A value of 0.0.0.0 will allow access from any IP
address. The name is the applicable community name.
Default 0.0.0.0
Format
snmp-server community ipmask <ipmask> <name>
Mode Global Config
no snmp-server community ipmask
This command sets a client IP mask for an SNMP community to 0.0.0.0. The name is the
applicable community name. The community name may be up to 16 alphanumeric characters.
Format
no snmp-server community ipmask <name>
Mode Global Config
snmp-server community mode
This command activates an SNMP community. If a community is enabled, an SNMP manager
associated with this community manages the switch according to its access right. If the community
is disabled, no SNMP requests using this community are accepted. In this case the SNMP manager
associated with this community cannot manage the switch until the Status is changed back to
Enable.
Default The default private and public communities are enabled by
default. The four undefined communities are disabled by default.
Format
snmp-server community mode <name>
To Next Page
Loading...
Need help?
General
