EasyManuals Logo

NETGEAR 7300 Series User Manual

NETGEAR 7300 Series
364 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #208 background imageLoading...
Page #208 background image
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-26 Routing Commands
202-10009-01_060204
ip ospf cost
This command configures the cost on an OSPF interface. The <cost> parameter has a range of 1 to
65535.
Default 10
Format
ip ospf cost <1-5535>
Mode Interface Config
no ip ospf cost
This command configures the default cost on an OSPF interface. The <cost> parameter has a range
of 1 to 65535.
Default 10
Format
no ip ospf cost
Mode Interface Config
ip ospf dead-interval
This command sets the OSPF dead interval for the specified interface.
The value for <seconds> is a valid positive integer, which represents the length of time in seconds
that a router's Hello packets have not been seen before its neighbor routers declare that the router is
down. The value for the length of time must be the same for all routers attached to a common
network. This value should be some multiple of the Hello Interval (i.e. 4).
Valid values range for <seconds> is from 1 to 2147483647.
Default 40
Format
ip ospf dead-interval <1-2147483647>
Mode Interface Config
no ip ospf dead-interval
This command sets the default OSPF dead interval for the specified interface.
Format
no ip ospf dead-interval
Mode Interface Config

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR 7300 Series and is the answer not in the manual?

NETGEAR 7300 Series Specifications

General IconGeneral
ModelNETGEAR 7300 Series
Form FactorRack-mountable
VLAN SupportYes
Jumbo Frame Support9KB
ManagementWeb-based, CLI
LayerLayer 2/3

Related product manuals