NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-17
202-10009-01_060204
The range of preference is 0 to 255.
Default Intra -- 8; Inter -- 10; Type-1 -- 13; Type-2 -- 150.
Format
distance ospf {intra | inter | type1 | type2} <0-255>
Mode Router OSPF Config
no distance ospf
This command sets the default route preference value of OSPF in the router. The type of OSPF can
be intra, inter, type-1, or type-2. Format
Format
no distance ospf {intra | inter | type1 | type2}
Mode Router OSPF Config
distance rip
This command sets the route preference value of RIP in the router. Lower route preference values
are preferred when determining the best route.
Default 15
Format
distance rip <0-255>
Mode Router RIP Config
no distance rip
This command sets the default route preference value of RIP in the router.
Format
no distance rip
Mode Router RIP Config
distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
Format
distribute-list <1-199> out {rip | bgp | static | con-
nected}
Mode Router OSPF Config

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3