User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-20 Switching Commands
202-10009-01_060204
Format no network javamode
Mode Privileged EXEC
network mac-address
This command sets locally administered MAC addresses. The following rules apply:
• Bit 6 of byte 0 (called the U/L bit) indicates whether the address is universally administered
(b'0') or locally administered (b'1').
• Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an individual
address (b'0') or a group address (b'1').
• The second character, of the twelve character macaddr, must be 2, 6, A or E.
A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0').
Format
network mac-address <macaddr>
Mode Privileged EXEC
network mac-type
This command specifies whether the burned in MAC address or the locally-administered MAC
address is used.
Default
burnedin
Format network mac-type {local | burnedin}
Mode Privileged EXEC
no network mac-type
This command resets the value of MAC address to its default.
Format
no network mac-type
Mode Privileged EXEC
network parms
This command sets the IP Address, subnet mask and gateway of the router. The IP Address and the
gateway must be on the same subnet.
Format
network parms <ipaddr> <netmask> [<gateway>]
To Next Page
Loading...
Need help?
General
