User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
DHCP Server Commands 12-7
202-10009-01_060204
show ip dhcp binding
This command displays address bindings for the specific IP address on the DHCP server. If no IP
address is specified, the bindings corresponding to all the addresses are displayed.
Format show ip dhcp binding [address]
Mode Privileged EXEC and User EXEC
IP address
The IP address of the client.
Hardware Address The MAC Address or the client identifier.
Lease expiration The lease expiration time of the IP Address assigned to the client.
Type The manner in which IP Address was assigned to the client.
show ip dhcp global configuration
This command displays address bindings for the specific IP address on the DHCP server. If no IP
address is specified, the bindings corresponding to all the addresses are displayed.
Format show ip dhcp global configuration
Mode Privileged EXEC and User EXEC
Service DHCP The field to display the status of dhcp protocol.
Number of Ping Packets The maximum number of Ping Packets that will be sent to verify
that an ip address id not already assigned.
Excluded Address The ranges of IP addresses that a DHCP server should not assign
to DHCP clients.
show ip dhcp pool configuration
This command displays pool configuration. If ‘*’ is specified, configuration for all the pools is
displayed.
Format show ip dhcp pool configuration {<name> | *}
Mode Privileged EXEC and User EXEC
Pool Name
The name of the configured pool.
Pool Type The pool type.
Lease Time The lease expiration time of the IP Address assigned to the client.
DNS Servers The list of DNS servers available to the DHCP client
Default Routers The list of the default routers available to the DHCP client
To Next Page
Loading...
Need help?
General
