NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-23
202-10009-01_060204
serial timeout
This command specifies the maximum connect time (in minutes) without console activity. A value
of 0 indicates that a console can be connected indefinitely. The time range is 0 to 160.
Default 5
Format
serial timeout <0 - 160>
Mode Line Config
no serial timeout
This command sets the maximum connect time (in minutes) without console activity to 5.
Format
no serial timeout
Mode Line Config
set prompt
This command changes the name of the prompt. The length of name may be up to 64 alphanumeric
characters.
Format
set prompt <prompt string>
Mode Privileged EXEC
show forwardingdb agetime
This command displays the timeout for address aging. In an IVL system, the [fdbid | all] parameter
is required. In an SVL system, the [fdbid | all] parameter is not used and will be ignored if entered.
Default
all
Format show forwardingdb agetime [fdbid | all]
Mode Privileged EXEC
Forwarding DB ID Fdbid (Forwarding database ID) indicates the forwarding data-
base whose aging timeout is to be shown. The all option is used to
display the aging timeouts associated with all forwarding data-
bases. This field displays the forwarding database ID in an IVL
system. This field will not be displayed in an SVL system.

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3