NETGEAR 7300 Series

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-5
202-10009-01_060204
no area stub
This command deletes a stub area for the specified area ID.
Format
no area <areaid> stub
Mode Router OSPF Config
area stub summarylsa
This command configures the Summary LSA mode for the stub area identified by <areaid>. The
Summary LSA mode is configured as enabled.
Default Disabled
Format
area <areaid> stub summarylsa
Mode Router OSPF Config
no area stub summarylsa
This command configures the default Summary LSA mode for the stub area identified by
<areaid>.
Format
no area <areaid> stub summarylsa
Mode Router OSPF Config
area virtual-link
This command creates the OSPF virtual interface for the specified <areaid> and <neighbor>. The
<neighbor> parameter is the IP address of the neighbor.
Format
area <areaid> virtual-link <neighbor>
Mode Router OSPF Config
no area virtual-link
This command deletes the OSPF virtual interface from the given interface, identified by <areaid>
and <neighbor>. The <neighbor> parameter is the IP address of the neighbor.
Format
no area <areaid> virtual-link <neighbor>
Mode Router OSPF Config