NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-19
202-10009-01_060204
Format no bridge aging-time [fdbid | all]
Mode Global Config
Forwarding Database ID Fdbid (Forwarding database ID) indicates which forwarding
database's aging timeout is being configured. All is used to con-
figure all forwarding database's agetime. In an SVL system, the
[fdbid/all] parameter is not used and will be ignored if entered.
mtu
This command sets the maximum transmission unit (MTU) size (in bytes) for physical and port-
channel (LAG) interfaces. For the standard implementation, the range of <mtusize> is a valid
integer between 1522-9216.
Default 1522
Format
mtu <1522-9216>
Mode Interface Config
no mtu
This command sets the default maximum transmission unit (MTU) size (in bytes) for the interface.
Format
no mtu
Mode Interface Config
network javamode
This command specifies whether or not the switch should allow access to the Java applet in the
header frame of the Web interface. When access is enabled, the Java applet can be viewed from the
Web interface. When access is disabled, the user cannot view the Java applet.
Default
Enabled
Format network javamode
Mode Privileged EXEC
no network javamode
This command disallows access to the Java applet in the header frame of the Web interface. When
access is disabled, the user cannot view the Java applet.

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3