NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-76 Switching Commands
202-10009-01_060204
Mode Global Config
vlan protocol group add protocol
This command adds the <protocol> to the protocol-based VLAN identified by <groupid>. A group
may have more than one protocol associated with it. Each interface and protocol combination can
only be associated with one group. If adding a protocol to a group causes any conflicts with
interfaces currently associated with the group, this command will fail and the protocol will not be
added to the group. The possible values for protocol are ip, arp, and ipx.
Default
none
Format vlan protocol group add protocol <groupid> <protocol>
Mode Global Config
no vlan protocol group add protocol
This command removes the <protocol> from this protocol-based VLAN group that is identified by
this <groupid>. The possible values for protocol are ip, arp, and ipx.
Format
no vlan protocol group add protocol <groupid> <proto-
col>
Mode Global Config
vlan protocol group remove
This command removes the protocol-based VLAN group that is identified by this <groupid>.
Format
vlan protocol group remove <groupid>
Mode Global Config
vlan pvid
This command changes the VLAN ID per interface.
Default
1
Format vlan pvid <1-4094>
Mode Interface Config

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3