EasyManuals Logo

NETGEAR 7300 Series User Manual

NETGEAR 7300 Series
364 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #196 background imageLoading...
Page #196 background image
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-14 Routing Commands
202-10009-01_060204
bootpdhcprelay serverip
This command configures the server IP Address for BootP/DHCP Relay on the system. The
<ipaddr> parameter is an IP address in a 4-digit dotted decimal format.
Default 0.0.0.0
Format
bootpdhcprelay serverip <ipaddr>
Mode Global Config
no bootpdhcprelay serverip
This command configures the default server IP Address for BootP/DHCP Relay on the system.
Format
no bootpdhcprelay serverip
Mode Global Config
clear arp-cache
This command causes all ARP entries of type dynamic to be removed from the ARP cache. If the
gateway parameter is specified, the dynamic entries of type gateway are purged as well.
Format
clear arp-cache [gateway]
Mode Privileged Exec
default-information originate (OSPF)
This command is used to control the advertisement of default routes.
Default value for metric unspecified
Default value for type 2
Format
default-information originate [always] [metric <0-
16777215>] [metric-type {1 | 2}]
Mode Router OSPF Config
no default-information originate (OSPF)
This command is used to control the advertisement of default routes.
Format
no default-information originate [metric] [metric-
type]

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR 7300 Series and is the answer not in the manual?

NETGEAR 7300 Series Specifications

General IconGeneral
ModelNETGEAR 7300 Series
Form FactorRack-mountable
VLAN SupportYes
Jumbo Frame Support9KB
ManagementWeb-based, CLI
LayerLayer 2/3

Related product manuals