User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
FSM7326P Power Over Ethernet Commands 13-3
202-10009-01_060204
poe priority
This command sets the priority level for the delivery of power to an attached device. The switch
may not be able to supply power to all connected devices, so the port priority is used to determine
which ports will supply power if adequate power capacity is not available for all enabled ports. For
ports that have the same priority level, the lower numbered port will have higher priority.
Default low
Format poe priority <high/medium/low>
Mode Global Config
poe limit
This command sets the power limit (in watts) for the port. The port will not supply more power
than the value specified as the limit.
For the FSM7326P, the valid range is 3 - 18.
Default 18
Format poe limit
Mode Global Config
poe usagethreshold
This command sets the power threshold level at which a trap will be generated. If the total power
consumed is greater than or equal to the specified percentage of the total power available, a trap
will be sent. The switch will continue to provide power even if the threshold is exceeded. The
threshold value is for providing a warning. It does not interrupt the power. Valid values are 0 - 100.
Default 80
Format poe usagethreshold <0-100>
Mode Global Config
show poe port info
This command displays a summary for the ports that support the PoE function.
Format show poe port <slot/port, All>
Mode Privilege
To Next Page
Loading...
Need help?
General
