User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-71
202-10009-01_060204
no vlan
This command deletes an existing VLAN. The ID is a valid VLAN identification number (ID 1 is
reserved for the default VLAN). VLAN range is 2-4094.
Format
no vlan <2-4094>
Mode VLAN database
vlan acceptframe
This command sets the frame acceptance mode per interface. For VLAN Only mode, untagged
frames or priority frames received on this interface are discarded. For Admit All mode, untagged
frames or priority frames received on this interface are accepted and assigned the value of the
interface VLAN ID for this port. With either option, VLAN tagged frames are forwarded in
accordance with the IEEE 802.1Q VLAN Specification.
Default
Admit All
Format vlan acceptframe {vlanonly | all}
Mode
Interface Config
no vlan acceptframe
This command sets the frame acceptance mode per interface to Admit All. For Admit All mode,
untagged frames or priority frames received on this interface are accepted and assigned the value
of the interface VLAN ID for this port. With either option, VLAN tagged frames are forwarded in
accordance with the IEEE 802.1Q VLAN Specification.
Format
vlan acceptframe {vlanonly | all}
Mode
Interface Config
vlan ingressfilter
This command enables ingress filtering. If ingress filtering is disabled, frames received with
VLAN IDs that do not match the VLAN membership of the receiving interface are admitted and
forwarded to ports that are members of that VLAN.
Default
Disabled
Format vlan ingressfilter
Mode Interface Config
To Next Page
Loading...
Need help?
General
