User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-26 Switching Commands
202-10009-01_060204
38400,57600, and 115200 baud. The factory Default is 9600
baud.
Character Size The number of bits in a character. The number of bits is always 8.
Flow Control Whether Hardware Flow-Control is enabled or disabled. Hard-
ware Flow Control is always disabled.
Stop Bits The number of Stop bits per character. The number of Stop bits is
always 1.
Parity Type The Parity Method used on the Serial Port. The Parity Method is
always None.
show serviceport
This command displays service port configuration information.
Format
show serviceport
Mode Privileged EXEC
IP Address The IP address of the interface. The factory default value is
0.0.0.0
Subnet Mask The IP subnet mask for this interface. The factory default value is
0.0.0.0
Default Gateway The default gateway for this IP interface. The factory default
value is 0.0.0.0
ServPort Configuration Protocol Current Indicates what network protocol was used on
the last, or current power-up cycle, if any.
Burned in MAC Address The burned in MAC address used for in-band connectivity.
show snmpcommunity
This command displays SNMP community information.
Six communities are supported. You can add, change, or delete communities. The switch does not
have to be reset for changes to take effect.
The SNMP agent of the switch complies with SNMP Version 1 (for more about the SNMP
specification, see the SNMP RFCs). The SNMP agent sends traps through TCP/IP to an external
SNMP manager based on the SNMP configuration (the trap receiver and other SNMP community
parameters).
To Next Page
Loading...
Need help?
General
