User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-6 Routing Commands
202-10009-01_060204
area virtual-link authentication
This command configures the authentication type and key for the OSPF virtual interface identified
by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor. The
value for <type> is either none, simple, or encrypt. The [key] is composed of standard displayable,
non-control keystrokes from a Standard 101/102-key keyboard. The authentication key must be 8
bytes or less if the authentication type is simple. If the type is encrypt, the key may be up to 256
bytes. Unauthenticated interfaces do not need an authentication key. If the type is encrypt, a key id
in the range of 0 and 255 must be specified.
Default The default value for authentication type is none. Neither the
default password key nor the default key id are configured.
Format
area <areaid> virtual-link <neighbor> authentication
{none | {simple <key>} | {encrypt <key> <keyid>}}
Mode Router OSPF Config
no area virtual-link authentication
This command configures the default authentication type for the OSPF virtual interface identified
by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor.
Format
no area <areaid> virtual-link <neighbor> authentica-
tion
Mode Router OSPF Config
area virtual-link dead-interval
This command configures the dead interval for the OSPF virtual interface on the virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the
neighbor. The range for <seconds> is 1 to 65535.
Default 40
Format
area <areaid> virtual-link <neighbor> dead-interval
<1-65535>
Mode Router OSPF Config
To Next Page
Loading...
Need help?
General
