NETGEAR 7300 Series

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-7
202-10009-01_060204
no area virtual-link dead-interval
This command configures the default dead interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of
the neighbor.
Format
no area <areaid> virtual-link <neighbor> dead-inter-
val
Mode Router OSPF Config
area virtual-link hello-interval
This command configures the hello interval for the OSPF virtual interface on the virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the
neighbor. The range for <seconds> is 1 to 65535.
Default 10
Format
area <areaid> virtual-link <neighbor> hello-interval
<1-65535>
Mode Router OSPF Config
no area virtual-link hello-interval
This command configures the default hello interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of
the neighbor.
Format
no area <areaid> virtual-link <neighbor> hello-inter-
val
Mode Router OSPF Config
area virtual-link retransmit-interval
This command configures the retransmit interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of
the neighbor. The range for <seconds> is 0 to 3600.
Default 5
Format
area <areaid> virtual-link <neighbor> retransmit-
interval <0-3600>