NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
CLI Commands: ACL 11-1
202-10009-01_060204
Chapter 11
CLI Commands: ACL
Show Commands
show ip access-lists
This command displays an Access Control List (ACL) and all of the rules that are defined for the
ACL. The <
accesslistnumber> is the number used to identify the ACL.
Format
show ip access-lists <accesslistnumber>
Mode Privileged EXEC and User EXEC
Rule Number This displays the number identifier for each rule that is defined
for the ACL.
Action This displays the action associated with each rule. The possible
values are Permit or Deny.
Protocol This displays the protocol to filter for this rule.
Source IP Address This displays the source IP address for this rule.
Source IP Mask This field displays the source IP Mask for this rule.
Source Ports This field displays the source port range for this rule.
Destination IP Address This displays the destination IP address for this rule.
Destination IP Mask This field displays the destination IP Mask for this rule.
Destination Ports This field displays the destination port range for this rule.
Service Type Field Match This field indicates whether an IP DSCP, IP Precedence, or IP
TOS match condition is specified for this rule.
Service Type Field Value This field indicates the value specified for the Service Type
Field Match (IP DSCP, IP Precedence, or IP TOS).

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3