Need help?Do you have a question about the NETGEAR GS308EPP and is the answer not in the manual?
General| Switch type | Managed |
|---|---|
| Switch layer | L2/L3 |
| Quality of Service (QoS) support | Yes |
| Installed SFP modules quantity | - |
| Basic switching RJ-45 Ethernet ports type | Gigabit Ethernet (10/100/1000) |
| Basic switching RJ-45 Ethernet ports quantity | 8 |
| 10G support | No |
| Networking standards | IEEE 802.3, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3at, IEEE 802.3u, IEEE 802.3x |
| Ethernet LAN data rates | 1000 Mbit/s |
| Jumbo frames | 9216 |
| MAC address table | 4000 entries |
| DHCP features | DHCP client |
| Certification | CE mark, commercial, FCC Part 15 class B, CE/EN55032/24, VCCI, ACMA, CSA safety, KC, BSMI |
| Product color | Black |
| LED indicators | Activity, Link, PoE, Power, System |
| AC input voltage | 100 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Operating altitude | 0 - 3000 m |
| Storage temperature (T-T) | -20 - 70 °C |
| Operating temperature (T-T) | 0 - 40 °C |
| Storage relative humidity (H-H) | 0 - 95 % |
| Operating relative humidity (H-H) | 0 - 90 % |
Weight and Dimensions| Depth | 101 mm |
|---|---|
| Width | 158 mm |
| Height | 27 mm |
| Weight | 490 g |
Provides essential safety guidelines for operating the switch.
Instructions for connecting and powering on the network switch.
Methods to find and connect to the switch on the network.
Using the NETGEAR Switch Discovery Tool to access the switch.
Configuring a static IP address for reliable switch access.
Configuring QoS modes and setting port traffic rate limits.
Adjusting port priority, rate limits, speed, and flow control.
Configuration and management of advanced port-based VLAN features.
Procedure to create new VLANs and assign ports in advanced mode.
Creating basic 802.1Q VLANs and assigning ports as members.
Configuration and management of advanced 802.1Q VLAN features.
Procedure to create new VLANs and assign ports in advanced 802.1Q mode.
Assigning a default VLAN ID (PVID) to ports in advanced 802.1Q VLANs.
Configuring a voice VLAN and adjusting its Class of Service (CoS) value.
Combining multiple Ethernet ports into a single logical link.
Procedure to disable DHCP and assign a fixed IP address to the switch.
Checking for firmware, updating the switch, and managing configuration files.
Troubleshooting steps for accessing the switch when IP subnets conflict.
To Next Page
