Need help?Do you have a question about the NETGEAR GS310TP and is the answer not in the manual?
General| Power connector | DC-in jack |
|---|---|
| SFP module slots quantity | 2 |
| Installed SFP modules quantity | 0 |
| Basic switching RJ-45 Ethernet ports type | Gigabit Ethernet (10/100/1000) |
| Basic switching RJ-45 Ethernet ports quantity | 8 |
| Output current | 1.25 A |
| Output voltage | 54 V |
| Power consumption (max) | 69.3 W |
| MAC address table | 8000 entries |
| Jumbo frames support | Yes |
| Total Power over Ethernet (PoE) budget | 55 W |
| Memory type | DDR-SDRAM |
| Flash memory | 32 MB |
| Internal memory | 128 MB |
| Processor frequency | 500 MHz |
| Mean time between failures (MTBF) | 1081119 h |
| Switch type | Managed |
| Switch layer | L2 |
| DHCP features | DHCP client |
| Authentication | Auto VLAN, Guest VLAN, MAC-based authentication, Port-based authentication, Web-based authentication |
| Authentication type | HWTACACS+, IEEE 802.1x |
| Security algorithms | 802.1x RADIUS, EAP, HTTPS, SSL/TLS |
| Access Control List (ACL) IPv4 entries | 100 |
| Stackable | - |
| Product color | Black |
| Rack mounting | No |
| Number of fans | 0 fan(s) |
| Number of VLANs | 64 |
| Networking standards | IEEE 802.1D, IEEE 802.1ab, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3at, IEEE 802.3az, IEEE 802.3x |
| Virtual LAN features | Voice VLAN |
| Operating temperature (T-T) | 0 - 40 °C |
| Number of multicast groups filtered | 256 |
| Harmonized System (HS) code | 85176990 |
Weight and Dimensions| Depth | 101 mm |
|---|---|
| Width | 263 mm |
| Height | 30 mm |
| Weight | 610 g |
Provides an overview of switch management interfaces for configuration, monitoring, and control.
Guides on how to access the switch's local browser-based management interface.
Describes displaying switch status and specifying basic information like IP address, clock, and DNS.
Explains configuring network information for the local browser interface.
Covers login password, RADIUS, TACACS+, and authentication list settings.
Restores system configuration to factory default values, losing all user-made changes.
Lists the default IP address, subnet mask, gateway, protocol, and other switch settings.
To Next Page
