NETGEAR GS310TP

Configure System Information
33
S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch Models GS308T and GS310TP
View and Configure the Switch Management Settings
This section describes how to display the switch status and specify some basic switch
information, such as the local browser interface IP address, system clock settings, and DNS
information. The following sections describe how you can configure the switch management
settings:
• View or Define System Information on page 33
• View the System CPU Status on page 36
• Configure the IP Network and VLAN Settings for the Local Browser Interface on page 38
• Configure the Time Settings on page 40
• Configure Denial of Service Settings on page 54
• Configure DNS Settings on page 57
• Configure Green Ethernet Settings on page 61
View or Define System Information
When you log in, the System Information page displays. You can configure and view general
device information.
 To view or define system information:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 11.
Your web browser might display a security message, which you can ignore. For more
information, see
Access the Local Browser Interface on page 19.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.