Configure Switching
110
S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch Models GS308T and GS310TP
6. In the LACP System Priority field, specify the switch’s link aggregation priority relative to
the devices at the other ends of the links on which link aggregation is enabled.
A higher value indicates a lower priority. You can change the setting globally by
specifying a priority from 1 to 65535.
The default value is 32768.
7. Click the Apply button.
Your settings are saved.
Set the LACP Port Priority Settings
The LACP port configuration page is used to configure the LACP priority value for the selected
port and the administrative LACP time-out value.
To configure LACP port priority settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is of
f-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser
, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 11.
Your web browser might display a security message, which you can ignore. For more
information, see Access the Local Browser Interface on page 19.
The login window opens.
4. Enter the switch’
s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching> LAG >
Advanced > LACP Port Configuration.
To Next Page
Loading...
