Need help?Do you have a question about the NETGEAR GS308EP and is the answer not in the manual?
General| Model | GS308EP |
|---|---|
| Category | Switch |
| Ports | 8 |
| PoE Ports | 8 |
| Total PoE Budget | 62W |
| Switching Capacity | 16 Gbps |
| MAC Address Table Size | 4K |
| Form Factor | Desktop |
| Jumbo Frame Support | Yes |
| VLAN Support | Yes |
| QoS | Yes |
| Energy Efficient Ethernet (EEE) | Yes |
| PoE Standards | IEEE 802.3af/at |
| Switch Type | Unmanaged |
| Forwarding Rate | 11.9 Mpps |
| Operating Humidity | 10% to 90% non-condensing |
| Operating Temperature | 0 to 40°C |
| Power Supply | External Power Adapter |
Lists all supported switch models and their descriptions.
Describes the physical switch label and front panel LED indicators.
Provides essential safety guidelines for using the device.
Step-by-step guide to physically connect and power the switch.
Methods to find the switch's IP address on the network.
Instructions for using the dedicated tool to find and access the switch.
How to configure a static IP for consistent access.
Procedures for customizing UI language and securing access with a new password.
Explains QoS modes and setting traffic rate limits for ports.
Details on configuring port priority, speed, flow control, and naming.
Introduces Virtual LANs and their basic concepts and types.
Covers activation and configuration of advanced port-based VLANs.
Details on configuring basic and advanced 802.1Q VLANs.
Configuration of port PVID, voice VLANs, and OUI settings.
How to enable or disable the switch discovery protocol.
Instructions for combining multiple ports into a single logical link.
Managing multicast traffic and IGMP snooping for network efficiency.
Changing the switch's IP address and managing DHCP settings.
Procedures for updating firmware and backing up/restoring configurations.
How to reset the switch to defaults and manage UI access restrictions.
Enabling Denial of Service prevention and power saving features.
Detailed information on Power over Ethernet port configuration and status.
Using the diagnostic feature to check network cable health.
Steps to fix issues when the switch and manager IP addresses are not on the same subnet.
Tips for resolving common Power over Ethernet problems.
Lists the default configuration parameters of the switch.
Provides detailed hardware specifications for different switch models.
Alternative methods for discovering and accessing the switch.
To Next Page
