EasyManuals Logo

NETGEAR GS308EP User Manual

NETGEAR GS308EP
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
Factory default settings
You can return the switch to its factory settings. Use the end of a paper clip or some
other similar object to press and hold the Reset button on the front panel of the switch
for at least ten seconds. The switch resets and returns to the factory settings that are
shown in the following table.
Table 7. Factory default settings
SettingFeature
passwordSwitch password
192.168.0.239 (if the switch is not connected to a network with a DHCP server)IP address
255.255.255.0Subnet mask
EnabledDHCP mode
EnabledIGMP snooping
None configuredLAGs
Disabled. If enabled, by default, all ports are members of VLAN 1.VLANs
Enabled802.1p/DSCP-based QoS
DisabledPort-based QoS
DisabledRate limiting
DisabledBroadcast filtering
DisabledLoop detection
AutonegotiationPort speed
DisabledFlow control
DisabledPort mirroring
User Manual90Factory Default Settings and
Technical Specifications
Gigabit Ethernet Smart Managed Plus Switches Series 3XXEP and 3XXEPP

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR GS308EP and is the answer not in the manual?

NETGEAR GS308EP Specifications

General IconGeneral
ModelGS308EP
CategorySwitch
Ports8
PoE Ports8
Total PoE Budget62W
Switching Capacity16 Gbps
MAC Address Table Size4K
Form FactorDesktop
Jumbo Frame SupportYes
VLAN SupportYes
QoSYes
Energy Efficient Ethernet (EEE)Yes
PoE StandardsIEEE 802.3af/at
Switch TypeUnmanaged
Forwarding Rate11.9 Mpps
Operating Humidity10% to 90% non-condensing
Operating Temperature0 to 40°C
Power SupplyExternal Power Adapter

Related product manuals