Manage Device Security
217
S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch Models GS308T and GS310TP
6. Select the Admin Mode Enable or Disable radio button.
This selection enables or disables secure HTTP (HTTPS). The default value is Enable.
Y
ou can download SSL certificates only when HTTPS is disabled. You can enable
HTTPS only if a certificate is present on the device.
7. In the HTTPS Port field, type the HTTPS port number
.
The range is from 1025 to 65535. The default is port 443.
8. In the HTTPS Session Soft T
imeout (Minutes) field, enter the inactivity time-out for
HTTPS sessions.
The range is from 1 to 60 minutes. The default value is 5 minutes.
9. In the HTTPS Session Hard T
imeout (Hours) field, set the hard time-out for HTTPS
sessions.
This time-out is unaffected by the activity level of the session. The range is from 1 to 168
hours.
The default is 24 hours.
10. In the Maximum Number of HTTPS Sessions field, enter the maximum allowable number
of HTTPS sessions.
The range is from 1 to 4 sessions. The default is 4 sessions.
11. Click the Apply button.
Your settings are saved.
Manage Certificates for HTTPS Access
You can manage certificates for HTTPS access.
Generate an SSL Certificate
To generate an SSL certificate:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is of
f-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser
, enter the IP address of the switch.
To Next Page
Loading...
