NETGEAR GS310TP

Configure Switching
165
S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch Models GS308T and GS310TP
• Search VLAN ID. From the Search menu, select VLAN ID, and enter the VLAN ID,
for example, 100. Then click the Go button.
• Search Interface. From the Search menu, select Interface, and enter the interface ID
using the respective interface naming convention (for example, g1 or l1).
Then click the
Go button.
The following table describes the nonconfigurable information displayed on the page.
Table 39. MAC Address Table information
Field Description
Total MAC Address The number of total MAC addresses learned or configured.
VLAN ID The VLAN ID associated with the MAC address.
MAC Address The unicast MAC address for which the switch holds forwarding and/or
filtering information.
The format is a 6-byte MAC address that is separated
by colons, for example 01:23:45:67:89:AB.
Interface The interface upon which this address was learned.
Status The status of this entry. The meanings of the values are as follows:
• Static.
The value of the corresponding instance was added by the
system or a user and cannot be relearned.
• Learned.
The value of the corresponding instance was learned, and is
being used.
• Management.
The value of the corresponding instance is also the
value of an existing instance of dot1dStaticAddress.
Set the Dynamic Address Aging Interval
You can set the address aging interval for the forwarding database.
 To set the address aging interval:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is of
f-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser
, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 11.
Your web browser might display a security message, which you can ignore. For more
information, see Access the Local Browser Interface on page 19.
The login window opens.
4. Enter the switch’
s password in the Password field.
The default password is password.