Need help?Do you have a question about the NETGEAR ProSafe XS748T and is the answer not in the manual?
Provides an overview of the switch management interface.
Guides on modifying the default IP address of the switch for remote management.
Configure network information for the management interface.
Configure global flow control and monitor port information for individual ports.
Add virtual LANs to segment networks and improve traffic management.
Configure routing settings for the switch.
Configure the switch with ports supporting VLANs and routing.
Directly configure aspects of switch queueing for desired QoS behavior.
Classify traffic into streams and give specific QoS treatment.
Configure management security settings for port, user, and server.
Configure global 802.1X port access control settings on the switch.
Enable and configure port access control on one or more ports.
Lock ports to allow only specific MAC addresses for forwarding packets.
Define rules for IP-based standard ACLs (basic ACLs).
Reboot the switch through the device reboot page.
Reset system configuration to factory default values, losing all changes.
Send a ping request to an IPv4 address to check switch communication.
To Next Page
General