23
sinusoidal waveforms. Such distortions of the sinusoidal waveform are caused e.g. by switching power
supplies.
Phase in degrees (°) is the value of a phase shift between current and voltage. Depends on a load
type connected to output. The value 0°/ 360° menas resistive load type.
Frequency in hertz [Hz].
Energy in watt-hours (Wh / kWh) is the cumulative energy consumed over a time interval. The
value is the total consumption at the output since the last reset of the counter.
Reverse Energy in watt-hours (Wh / kWh) is the cumulative energy delivered back to grid over a
time interval. The value is the total power supply at the output since the last reset of the counter.
All outputs section contains values calculated for the whole device so these apply for the power
input cable/connection. Values showing N/A are not available for this type of device. The “Total
Energy NR” and “Total Reverse Energy NR” are the non-resettable (NR) counters counting energy
since the device has been manufactured and first powered on.
By default, the cumulative Energy consumption/delivery and Total Energy consumption/delivery are
counted from the time the NETIO device was first powered on. To reset all Energy counters, go to
the Settings > System tab and click the Reset Power Consumption Counters button (see Figure
18). This restarts the measurements as of the current moment and the date/time shown change.
Figure 14 – Resetting the consumption counters
To Next Page
Loading...
