Netio PowerBOX 4KE - M2 M API Protocol - SNMP

55
5.2.8 M2M API Protocol – SNMP
Figure 26 – SNMP API protocol configuration
Enable SNMP
Enables M2M SNMP API functions in the system.
The port is 161.
SNMP version
1,2c – unsecured, unencrypted
3 – secured
Location
Define system location (sysLocation).
Community READ
Also called the “community string” in SNMP. Similar to a
username/password combination. Needed for reading information from
NETIO device over SNMP.
We recommend to use “pure” ASCII characters (that is, to avoid
accented and special characters, such as @, & and so on, if possible).
Community WRITE
Also called the “community string” in SNMP. Similar to a
username/password combination. Needed for writing commands to
NETIO device over SNMP.
We recommend to use “pure” ASCII characters (that is, to avoid
accented and special characters, such as @, & and so on, if possible).
Save Changes
Saves the changes.