Netio PowerBOX 4KE - M2 M API Protocol - Telnet

40
5.2.4 M2M API Protocol – Telnet
Figure 22 –Telnet protocol configuration
Enable Telnet
Enables M2M Telnet functions in the system.
Port
Specific port for Telnet only, range 1 – 65535. Be aware, that you
should enter value, which is not already occupied by another M2M
protocol or web interface.
Enable READ-ONLY
Enables Read-Only access via M2M Telnet API for monitoring. You may
also fill in the username and password for this mode.
Enable READ-WRITE
Enables Read/Write access for monitoring and output control. You may
also fill in the username and password for this mode.
Username
Username for the respective access mode (Read-Only/ReadWrite). Note
– this is unrelated to the username for accessing the NETIO device web
administration. When left empty, the protocol will not require any
authentication.
Password
Password for the corresponding username (Read-Only/ReadWrite).
Save Changes
Saves the changes.