When the Netio Push is enabled, other M2M protocols are disabled. After clicking Save changes, you
will be asked to confirm the deactivation of the other protocols.
Click Confirm to confirm the action or Cancel to return to the Netio Push protocol configuration.
Data (payload – JSON/XML) are automatically periodically sent to the target address using HTTP(s),
depending on the configured push period.
Output control over the NETIO PUSH – JSON
Device is periodically connecting to the Target host http(s) server within push period (default
60seconds). It means the output can be switched only when the TCP/IP connection is established. In
default once every 60 seconds.
If the response from Target host is error code 200 (OK) and the payload contains valid NETIO JSON
structure with control command then the Output will be set accordingly. This way is possible to
control device even if this is in private network behind NAT.
The NETIO JSON structure is described in section M2M API Protocol – JSON (REST M2M API).
For more information about the M2M HTTP(s) Push API, visit the Support
> Download section of our website and see the following document:
HTTP(s) Push JSON - description of NETIO M2M API interface - PDF
To Next Page
Loading...
