Netio PowerBOX 4KE - Page 9

9
PowerUp State
The PowerUp State parameter (sometimes also called Cold start) defines the
behavior of the 110/230V power output during the first milliseconds to seconds
after powering up the device, before the LAN/WiFi communication with a
master system is established.
For some applications, it is important to set the correct state of a power
output immediately after power is turned on (or restored). With servers in
particular it is important to avoid undesired momentary switching.
Possible settings for NETIO device
- On
- Off
- LAST state restores the last state before the power was disconnected
Electrical measurements – only PowerBOX 4Kx
PowerBOX 4Kx measures relevant electrical parameters.
Parameter
Range
Units
Resolution
Accuracy
Voltage
90,0 – 250,0
V
0,1
<1%
Frequency
45,0 – 65,0
Hz
0,1
<1%
Current
0,005 – 16,000
A
0,001
<1%
TPF
(True Power Factor)
0,00 – 1,00
-
0,01
<1%
Phase
0 – 360
°
0,01°
<1%
Output power
0 – 3600
W
1
<1%
Energy
0 - 4294967296
Wh
1
<1%
Reverse Energy
0 - 4294967296
Wh
1
<1%
PowerUp
state