ADSL2+ Modem Router User Manual
32
4.3.3.1 Basic Settings
Go to Setup->WLAN->Basic page, you can configure the wireless parameters.
Here you may enable or disable the wireless function. You can also change the wireless
parameters, such as Band, SSID, Channel Width, Control Sideband, Channel Number and Radio
Power.
Band: In the drop-down list you can select the band type. For example: 2.4G b+g+n allows 2.4G
802.11b, 802.11g and 802.11n wireless clients to connect to this wireless Modem Router.
Mode: In the drop-down list, you can select AP or AP+WDS, which allows wireless station to
associate with AP or AP+WDS.
Channel Number: Select the channel you want to use from the drop-down List of channel. This
field determines which operating frequency will be used. It is not necessary to change the wireless
channel unless you notice interference problems with another nearby access point.
Channel Width: Select the Channel Width you want to use from the drop-down List. If bigger
bandwidth is selected, device could transmit and receive data with higher speed.
To Next Page
Loading...
Need help?
General
