settings to the factory configuration.
The other way to restore factory settings is through the same user interface used in setup.
Click on ‘System management’- ‘Restore’, and click on the ‘Restore’ button.
2.4. Hardware Installation Procedures
The procedures to install the 150Mbps/300Mbps Wireless-N AP/ Repeater / Router client
please refers to the following picture
Figure 2-3
Ø Attach one end of an Ethernet cable to your computer’s Ethernet port, and the other end to
one of the LAN ports of your router.
Ø Connect another Ethernet cable from your Cable/DSL modem to the WAN port of your
router.
Ø Connect the single DC output connector of the power adapter to the power jack on the back
of the router and plug the Power Adapter into an AC outlet.
To Next Page
Loading...
