SNMPv1 config
/------------------------/
/ SNMPV1 config /
/------------------------/
Trap receiver 1:powernetguard
Trap receiver 2:192.168.5.96
Trap receiver 3:
Trap receiver 4:
Trap receiver 5:
Trap receiver 6:
Trap receiver 7:
With this menu the IP addresses to which traps are sent can be configured. Traps are SNMP
messages that are sent to an SNMP manager for alarm notification.
Traps can be sent to seven different hosts.
SNMPv1 community
/------------------------/
/ SNMPV1 community /
/------------------------/
Get community..:public
Set community..:private
Trap community.:public
With this menu the protection password of the SNMP messages (SNMP Communities) can be
configured as described in the following table.
Field Parameters to be inserted
Get community Enter the community for read access
Set community Enter the community for write access
Trap community Enter the community for traps
- 22 -
To Next Page
Loading...
