5.2 SETTINGS
A. Operation mode setting
a.
Normal Operation
Press POWER key to turn on the unit.
Press the HUM/CNT key to activate the AUTO mode.
The unit operates in auto mode with the default 60% humidity set-point.
b. Continuous Operation
Press POWER key to turn on the unit and operates in continuous mode automatically.
The unit starts to dehumidify in continuous operation with the default 20% relative humidity. The fan
runs at high speed. The display reads current relative humidity. The humidity set-point cannot be
adjusted in this mode.
Press POWER key again to turn off the dehumidifier.
The fan keeps running for a while and then stops.
Note: For continuous operation the drain hose should be connected in order to continuously drain the
collected water.
B.
Set Humidity (setting range: 40%-80%):
The humidity set-point can be adjusted in Auto mode.
Press HUM/CNT key repeatedly to adjust humidity set-point by increments of 5%.The unit will
cycle on and off to maintain the level.
Set the humidity level between 40% and 60% for comfort.
C. Set Fan Speed:
Press SPEED key to switch the speed between high and low.
Note: The fan speed cannot be set when in defrosting progress.
D. Room Temperature Inspection
In addition to the humidity level, the digital display can also indicate the current room temperature.
Please check as follows:
Press and hold the HUM/CNT button for 5 seconds.
The screen displays the temperature in degree Celsius for 5 seconds.
E. Timer Setting
（0hour-24hours）:
The timer has two ways of operation:
To turn off
(When power on)
To turn on
(When power off)
Cancel timer
Press TIMER key to
turn on the timer
function.
Press TIMER key to
turn on the timer
function.
Press
TIMER
repeatedly to set the
delay OFF time.
Press TIMER
repeatedly to set the
delay ON time.
Press TIMER key to activate the timer function then
press TIMER until shows “00”, the Timer LED turn off.
Note: when press POWER will also exit the timer setting.
To Next Page
