5.3 DRAINAGE
There are two ways of removal collected water produced by the unit.
A. Manual draining: Empty water tank by manual.
B. Continuous draining: Use gravity to drain condensate water by attaching a drain hose.
5.3.1 EMPTYING THE WATER TANK
The water tank built in unit will fill up and shut the unit down once it is full. It will run again once you
empty the water tank and installed properly.
1) When the tank is full, The unit will make a buzzing sound, and the “FULL” light will turn on.
2) Press the POWER button to turn off the unit.
3) Pull on the water tank and simply slide out of the body of the dehumidifier.
4) Empty the water into an area with a drain or outside.
5) Clean the inside of the tank as well as the outside.
6) Replace the empty tank back into the unit.
7) Press the POWER button to resume operation.
8) If the FULL light does not extinguish, check that the float is correctly in place.
Pic1. Pull out the water tank
Pic2. Empty the water tank
Pic3. Don't remove the float
To Next Page
